Hitachi HGST 800GB 800 GB SAS SSD MLC HUSMM1680ASS201 Hard Drive 2.5" 12GBPS 512

Description

These are lightly used 800GB HGST SAS SSDs taken from an EMC storage rack, secure erased, formatted, increased to 12GBPS (they were sometimes sold limited to 6GBPS) , performance tested, and verified with Smartctl.
Please note: these are not SATA or PCIE SSDs, they won't typically work in a desktop unless you have an HBA.
They average around 200-400 total TB written. They have 14.6 PB lifetime endurance, so by that measure they're at 98% of their lifetime writes. This era of MLC NAND was specced to be bulletproof, and has extremely consistent throughput.
Here is the datasheet: https://documents.westerndigital.com/content/dam/doc-library/en_us/assets/public/western-digital/product/data-center-drives/ultrastar-sas-series/data-sheet-ultrastar-ssd1600mm.pdf
Here is the manual: https://documents.westerndigital.com/content/dam/doc-library/en_us/assets/public/western-digital/product/data-center-drives/ultrastar-sas-series/product-manual-ultrastar-ssd800mh-b-ssd1600mm-and-ssd1600mr.pdf
Let me know if you have any questions. Thanks.
Hitachi HGST 800GB 800 GB SAS SSD MLC
HUSMM1680ASS201
Hard Drive 2.5"12 GBPS. Condition is "Seller refurbished".
Sample Smartctl readout:
smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-73-generic] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor:               HITACHI
Product:              HUSMM118 CLAR800
Revision:             C250
Compliance:           SPC-4
User Capacity:        800,176,914,432 bytes [800 GB]
Logical block size:   512 bytes
Physical block size:  4096 bytes
LU is resource provisioned, LBPRZ=1
Rotation Rate:        Solid State Device
Form Factor:          2.5 inches
Logical Unit id:      0x5000cca04f16a534
Serial number:        0RVDG2EA
Device type:          disk
Transport protocol:   SAS (SPL-3)
SMART support is:     Available - device has SMART capability.
SMART support is:     Enabled
Temperature Warning:  Enabled
Read Cache is:        Enabled
Writeback Cache is:   Disabled
=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Percentage used endurance indicator: 2%
Current Drive Temperature:     27 C
Drive Trip Temperature:        70 C
Manufactured in week 20 of year 2015
Specified cycle count over device lifetime:  0
Accumulated start-stop cycles:  0
Specified load-unload count over device lifetime:  0
Accumulated load-unload cycles:  0
Elements in grown defect list: 0
Vendor (Seagate Cache) information
Blocks sent to initiator = 29703064
Error counter log:
Errors Corrected by           Total   Correction     Gigabytes    Total
ECC          rereads/    errors   algorithm      processed    uncorrected
fast | delayed   rewrites  corrected  invocations   [10^9 bytes]  errors
read:          0        0         0         0          0     221401.290           0
write:         0        0         0         0          0     307662.046           0
Non-medium error count:        0
No Self-tests have been logged
Background scan results log
Status: waiting until BMS interval timer expires
Accumulated power on time, hours:minutes 46213:40 [2772820 minutes]
Number of background scans performed: 30,  scan progress: 0.00%
Number of background medium scans performed: 30
Protocol Specific port log page for SAS SSP
relative target port id = 1
generation code = 3
number of phys = 1
phy identifier = 0
attached device type: expander device
attached reason: SMP phy control function
reason: unknown
negotiated logical link rate: phy enabled; 12 Gbps
attached initiator port: ssp=0 stp=0 smp=0
attached target port: ssp=0 stp=0 smp=1
attached phy identifier = 0
Invalid DWORD count = 4
Running disparity error count = 4
Loss of DWORD synchronization = 3
Phy reset problem = 0
Phy event descriptors:
Invalid word count: 4
Running disparity error count: 4
Loss of dword synchronization count: 3
Phy reset problem count: 0