Digital LED Microcomputer Thermostat - Controller Switch Temperature Sensor 12V

Description

Temperature Controller
Visit store
ONE
DC12V Digital Display - Microcomputer Temperature Controller
Will change between Fahrenheit or Celsius
Can be set for Cooling or Heating
Has a differential setting for span between on and off conditions
Has a sensor offset for application calibration
Has Set Point time delay for debounce if needed
A high temperature alarm beep can be programmed
GS02051-01
XD-2048 (12V) With 20A relay
comes with easy to understand English instructions
Uses
incubators Hatchery Air conditioning Furnace
aquarium heaters attic vents and greenhouse fans
Temperature measurement range: -50 ℃ ~ 110 ℃ Resolution: 0.1 ℃ when -9.9-99.9 other temperature ranges 1 ℃
Accuracy: ± 0.1 ℃
control accuracy: 0.1 ℃
Backlash accuracy: 0.1 ℃
Refresh rate: 0.5S
High-temperature protection: 0-110 ℃ Not recommended to use above 250 F
Input voltage: DC12V
Measuring input: NTC (10K 0.5%) Waterproof sensor  Not rated above 110 C or 250 F
Output: one 20A relay at 14V DC  and 20A at 125 VAC
Environmental requirements: -10 ℃ --60 ℃ humidity 20% - 85%
Size: 48mm (length) * 29mm * wide Depth: 32mm
Hole size: 46 * 26.5mm = 1 3/4 " X 1"
Power consumption: Static current ≤35MA pull current: ≤65MA
Connect the power supply and the load supply to the controller,
The measured temperature is displayed as red, blue below is set point
Press SET and C to raise the set point or F to lower the desired set temperature. 3 seconds after setting the automatic returns to
operation
LEDs, LED Status Description.
LED: Off indicates the relay is open,
LED On indicates relay is closed.
I am a retired Industrial technician. I am using Ebay to supplement a retirement check.
There is no attempt to get rich doing this. I only pray to make a few dollars and serve a purpose
in my retirement years. Great service, integrity & honesty are my goals
Ask questions we really don't mind